LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Lubrication System (2GR-FKS) (Service Information) (Except Hybrid)) >> Oil Pressure Switch >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT FENDER APRON SEAL RH 

    Refer to PROCEDURE - Step 14

  2. DRAIN ENGINE OIL 

    See step  1

  3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the wire harness protector.
      GTY625343Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Wire Harness Protector
    2. Disconnect the engine oil pressure switch assembly connector.
    3. Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
      GTY666516Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals