LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Lubrication System (2GR-FKS) (Service Information) (Except Hybrid)) >> Oil Pan And Oil Level Sensor >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. SUPPORT AUTOMATIC TRANSAXLE ASSEMBLY 
    1. Set an engine lifter.
      NOTE:

      Make sure that there is clearance between the automatic transaxle assembly and engine lifter.

      GTY719187Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ENGINE OIL LEVEL SENSOR 
    1. Install the engine oil level sensor to the oil pan sub-assembly with the 2 nuts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Install a new clip to the engine oil level sensor.
  3. INSTALL OIL STRAINER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 53

  4. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 54

  5. INSTALL BELT 

    Refer to PROCEDURE - Step 15

  6. INSTALL FRONT FRAME ASSEMBLY 

    Refer to INSTALLATION [11/2016 - ]

  7. ADD ENGINE OIL 

    See step  4

  8. INSPECT OIL LEAK 

    See step  5

scientia non olet · About LEMON Manuals