LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Lubrication System (2GR-FKS) (Service Information) (Except Hybrid)) >> Engine Oil Cooler >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OIL COOLER ASSEMBLY 
    1. Install the No. 1 cylinder block insulator and 2 new O-rings to the No. 1 oil cooler bracket.
    2. Install the oil cooler assembly to the No. 1 oil cooler bracket with the 2 bolts and 2 nuts.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

    3. Connect the No. 4 water by-pass hose and No. 5 water by-pass hose to the oil cooler assembly, and slide the 2 clips to secure them.
    4. Install the hose clamp with the nut to the cylinder block sub-assembly.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

  2. INSTALL EXHAUST MANIFOLD ASSEMBLY LH 

    Refer to INSTALLATION [11/2016 - ]

  3. ADD ENGINE OIL 

    See step  4

  4. CHECK ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  5. INSPECT FOR OIL LEAK 

    See step  5

  6. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  7. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 3

scientia non olet · About LEMON Manuals