LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission (UA80F) - Service Information (1 Of 2) (Except Hybrid)) >> Pattern Select Switch >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE FRONT PANEL GARNISH LH 

    Refer to PROCEDURE - Step 2

  3. REMOVE FRONT PANEL GARNISH RH 

    Refer to PROCEDURE - Step 3

  4. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 4

  5. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 5

  6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6

  7. REMOVE NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 31

  8. REMOVE PATTERN SELECT SWITCH ASSEMBLY 
    GTY429761Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disengage the 2 claws and remove the pattern select switch assembly from the No. 2 switch hole base.
scientia non olet · About LEMON Manuals