LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission (UA80F) - Service Information (1 Of 2) (Except Hybrid)) >> Pattern Select Switch >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT PATTERN SELECT SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY447774Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected (Pattern Select Switch Assembly)

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      8 (2ND) - 5 (E) Pattern select switch on (Push) Below 1 Ω
      Pattern select switch off (Release) 10 kΩ or higher

      If the result is not as specified, replace the pattern select switch assembly.

    2. Apply battery voltage between the terminals of the pattern select switch assembly, and check the illumination condition of the pattern select switch assembly.

      Standard

      Measurement Condition Specified Condition
      Battery positive (+) → Terminal 7 (ILL+)
      Battery negative (-) → Terminal 6 (ILL-)      		 Illuminates
      GTY447772Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected (Pattern Select Switch Assembly)

      If the result is not as specified, replace the pattern select switch assembly.

scientia non olet · About LEMON Manuals