LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission (UA80F) - Service Information (1 Of 2) (Except Hybrid)) >> Park / Neutral Position Switch >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [11/2016 - ]

  2. SECURE VEHICLE 
    1. Fully apply the parking brake and chock a wheel.
      WARNING:
      • Make sure to apply the parking brake and chock a wheel before performing this procedure.
      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
      GTY655852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 2

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
    1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.
  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 
    1. Remove the 2 bolts.
      GTY737010Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide from the grommet of the air cleaner support bracket to remove the air cleaner case sub-assembly.
  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Remove the clip as shown in the illustration and disconnect the transmission control cable assembly from the transmission control shaft lever.
      GTY739336Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Clip
  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Disconnect the park/neutral position switch assembly connector.
      GTY694241Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.
    3. Remove the 2 bolts and park/neutral position switch assembly from the automatic transaxle case sub-assembly.
      GTY722540Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.

scientia non olet · About LEMON Manuals