Replacement [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 8
REMOVE FRONT FENDER APRON SEAL LH
Refer to PROCEDURE - Step 13

DRAIN AUTOMATIC TRANSAXLE FLUID

Remove the refill plug and gasket from the automatic transaxle case sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a 10 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle housing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle housing and drain the automatic transaxle fluid.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	No. 1 Transmission Oil Filler Tube

Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle housing.
Torque: 1.7 N*m (17 kgf*cm, 15 in.*lbf)
Using a 10 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the transaxle housing.
HINT:

Reuse the old gasket as the overflow plug will be removed again to adjust the automatic transaxle fluid level.
Temporarily install the gasket and refill plug to avoid automatic transaxle fluid spillage.
HINT:

Reuse the old gasket as the refill plug will be removed again to adjust the automatic transaxle fluid level.

REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Refer to REMOVAL [11/2016 - ]

REMOVE FRONT DRIVE SHAFT OIL SEAL LH

Using SST, remove the front drive shaft oil seal LH from the automatic transaxle case sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

SST: 09308-00010

NOTE:

Be careful not to damage the automatic transaxle case sub-assembly.

INSTALL FRONT DRIVE SHAFT OIL SEAL LH

Using SST and a hammer, install a new front drive shaft oil seal LH to the automatic transaxle case sub-assembly.

Depth

SST: 09316-10010
SST: 09950-70010
1. 09951-07100

Standard Depth

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTE:

Make sure that the front drive shaft oil seal LH is installed in the correct direction.
Do not damage the lip of the front drive shaft oil seal LH.

INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Refer to INSTALLATION [11/2016 - ]
ADJUST AUTOMATIC TRANSAXLE FLUID
Refer to ADJUSTMENT [11/2016 - ]
INSPECT FOR FLUID LEAK
INSTALL FRONT FENDER APRON SEAL LH
Refer to PROCEDURE - Step 97
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 103