LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Automatic Transmission (UA80E) - Service Information (1 Of 2)) >> Valve Body Assembly >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE TRANSMISSION WIRE 

    Refer to REMOVAL [11/2016 - ] 

  2. REMOVE TRANSMISSION VALVE BODY ASSEMBLY (w/o Stop And Start System) 
    1. Disengage the clamp to disconnect the transmission revolution sensor (NC) wire connector.
      GTY694199Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 9 bolts and transmission valve body assembly from the automatic transaxle case sub-assembly.
      GTY694200Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 transaxle case gaskets from the automatic transaxle case sub-assembly.
      GTY713641Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transaxle Case Gasket
      *2 No. 1 Front Oil Pump Cover Gasket
      *3 No. 2 Front Oil Pump Cover Gasket
    4. Remove the transaxle case gasket from the counter drive gear sub-assembly.
    5. Remove the No. 1 front oil pump cover gasket from the front oil pump assembly.
    6. Remove the No. 2 front oil pump cover gasket from the front oil pump assembly.
  3. REMOVE TRANSMISSION VALVE BODY ASSEMBLY (w/ Stop And Start System) 
    1. Disengage the clamp to disconnect the transmission revolution sensor (NC) wire connector.
      GTY694199Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 9 bolts and transmission valve body assembly from the automatic transaxle case sub-assembly.
      GTY737842Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 transaxle case gaskets from the automatic transaxle case sub-assembly.
      GTY711873Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transaxle Case Gasket
      *2 No. 1 Front Oil Pump Cover Gasket
      *3 No. 2 Front Oil Pump Cover Gasket
    4. Remove the transaxle case gasket from the counter drive gear sub-assembly.
    5. Remove the transaxle case gasket from the front oil pump assembly.
    6. Remove the No. 1 front oil pump cover gasket from the front oil pump assembly.
    7. Remove the No. 2 front oil pump cover gasket from the front oil pump assembly.
scientia non olet · About LEMON Manuals