Installation [11/2016 - ]: Procedure

1. Pass the transmission control cable assembly from the cabin to the engine compartment.
2. Install the transmission control cable assembly with the 3 bolts.

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

3. Install the dash panel insulator to the original position.
4. Engage the transmission control cable assembly to the No. 3 transmission control cable bracket.
5. Install a new clip to the No. 1 transmission control cable bracket.
6. Connect the transmission control cable assembly to the No. 1 transmission control cable bracket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Claw A
   *b	Claw B
   *c	Transmission Control Cable Assembly

   NOTE:

   • Make sure that the claws A on the clip are securely fit into the No. 1 transmission control cable bracket holes.
   • Make sure that the transmission control cable assembly is securely installed inside of the claws B of the clip.
7. Connect the transmission control cable assembly to the transmission control shaft lever and install the clip.
   NOTE:

   Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.

8. Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration and pull the lock piece outward.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Slider
   *b	Lock Piece
   *c	Slide
   *d	Pull

9. Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lock Nut
   *b	Push in
   *c	Stopper

10. Install the transmission control cable assembly to the transmission floor shift assembly.
    NOTE:

    After installation, check that the outer part of the stopper is protruding beyond portion A-A as shown in the illustration.

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    *a

    Stopper

11. Install the transmission control cable assembly to the transmission floor shift assembly.
    NOTE:

    • Check that the lock piece is pulled out.
    • Install the cable end all the way to the base of the transmission floor shift assembly pin.

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    *a	Lock Piece
    *b	Adjuster Case

12. Push the lock piece into the adjuster case.
    NOTE:

    • Check that the park/neutral position switch assembly and shift lever are in neutral.
    • Securely push in the lock piece until the slider lock is engaged.

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to INSTALLATION [11/2016 - ]

See step  3

See step  4

Refer to PROCEDURE - Step 3

See step  2

Refer to ADJUSTMENT [11/2016 - ]