Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 8

REMOVE TRANSMISSION OIL COOLER AIR DUCT

Remove the bolt.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Turn back the front fender liner LH.

Remove the 3 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the guide to remove the transmission oil cooler air duct from the oil cooler assembly.

DISCONNECT OIL COOLER HOSE

Slide the 2 clips and disconnect the outlet No. 2 oil cooler hose and No. 2 transmission oil cooler hose from the oil cooler assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Outlet No. 2 Oil Cooler Hose
*2	No. 2 Transmission Oil Cooler Hose

NOTE:

Use a container to catch any fluid which flows out of the outlet No. 2 oil cooler hose, No. 2 transmission oil cooler hose and oil cooler assembly.

REMOVE OIL COOLER ASSEMBLY

Remove the 2 nuts and oil cooler assembly from the oil cooler bracket.

NOTE:

Use a container to catch any fluid which flows out of the oil cooler assembly.

REMOVE OIL COOLER BRACKET

HINT:

Perform this procedure only when replacement of the oil cooler bracket is necessary.

Remove the bolt, nut and oil cooler bracket from the vehicle body.

*a	Bolt
*b	Nut