Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STARTER ASSEMBLY

Type B:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	26.5 mm (1.043 in.)
*b	18 mm (0.709 in.)
*c	50 mm (1.969 in.)

Using an E8 "TORX" socket wrench, install the 2 stud bolts to the automatic transaxle assembly.

Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)

Install the starter assembly with the 2 nuts.
Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)

Type A:
1. Install the starter assembly with the 2 bolts.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
Connect terminal 30 with the nut.
Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
Close the terminal cap.
Connect the starter assembly connector.

INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 62
INSTALL INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 63
INSTALL BATTERY
Refer to PROCEDURE - Step 64
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 91
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
INSTALL RADIATOR SIDE SEAL RH
Refer to PROCEDURE - Step 5
INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
Refer to PROCEDURE - Step 6
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [11/2016 - ]