Television Display Power Source Circuit [12/2013 - ]: Procedure

1. Disconnect the S8 television display assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   S8-17 (GND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   S8-1 (+B) - S8-17 (GND)	Always	11 to 14 V
   S8-2 (ACC) - S8-17 (GND)	Engine switch on (ACC)	11 to 14 V

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE: 

Refer to PROBLEM SYMPTOMS TABLE [12/2013 - ] .

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR