Inspection [12/2013 - 11/2016]: Procedure

1. Inspect the tires for wear and proper inflation pressure.

   Cold Tire Inflation Pressure

   Tire Size	Cold Tire Inflation Pressure
   	Front	Rear
   245/60R18 P245/60R18 245/55R19	240 kPa (2.4 kgf/cm2 , 35 psi)	240 kPa (2.4 kgf/cm2 , 35 psi)

2. Using a dial indicator, check the runout of the tires.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Maximum Tire Runout

   1.4 mm (0.0551 in.)

1. Rotate the tires as shown in the illustration (A). If the vehicle is equipped with a full size spare tire, rotate the tires as shown in the illustration (B).

   Axle Hub Nut 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Front

1. Inspect and adjust the off-the-car balance.

   Maximum Imbalance

   8.0 g (0.0176 lb)

   NOTE:

   • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
   • Do not touch the adhesive surface of the balance weight.
   • Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.
   • Push the balance weight with your finger to securely adhere it to the desired position.
   • Do not reuse balance weights.

   HINT: 

   Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	25 mm (0.984 in.)

Refer to ON-VEHICLE INSPECTION [12/2013 - ]

Refer to ON-VEHICLE INSPECTION [12/2013 - ]