LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 216 (Battery / Charging System (Service Information) (Hybrid)) >> Auxiliary Battery >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.
      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Refer to INITIALIZATION [11/2016 - ]

  4. REMOVE DECK SIDE TRIM BOX LH 

    Refer to PROCEDURE - Step 3

  5. REMOVE BATTERY SERVICE HOLE COVER 
    1. Disengage the 6 claws and 2 guides to remove the battery service hole cover.
      GTY428639Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE AUXILIARY BATTERY 
    1. Open the battery terminal cap.
      GTY428640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.
    3. Remove the nut and bolt.
      GTY451452Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the battery clamp sub-assembly from the auxiliary battery.
    5. Disconnect the battery hose from the auxiliary battery.
      GTY428641Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the auxiliary battery.
    7. Remove the battery insulator from the auxiliary battery.
scientia non olet · About LEMON Manuals