Typical Enabling Conditions
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Spark cut | Not operating |
| Either of the following conditions is met | A or B |
| A. Engine speed | 1500 rpm or less |
| B. Starter | Off |
| Either of the following conditions is met | C or D |
| C. Both of the following conditions are met | - |
| Engine speed | 500 rpm or less |
| Battery voltage | 6 V or higher |
| D. All of the following conditions are met | - |
| Engine speed | Higher than 500 rpm |
| Battery voltage | 10 V or higher |
| Number of sparks after CPU reset | 5 sparks or more |
| Idling stop control (w/ stop and start system) | Not operating |