Installation [12/2013 - ]: Procedure

1. Install a new rear drive shaft snap ring.
   NOTE:

   Face the end gap of the rear drive shaft snap ring downward.

1. Apply Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent to the area shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent

2. Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Face the end gap of the rear drive shaft snap ring downward.
   • Do not damage the rear drive shaft oil seal.
   • Do not damage the rear drive shaft inboard joint boot.
   • Make sure to center the rear drive shaft assembly during installation to prevent damage to the rear drive shaft snap ring.

   HINT: 

   Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 5

Refer to INSTALLATION [12/2013 - ]