LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft / Propeller Shaft (Service Information) (Except Hybrid) >> FRONT DRIVE SHAFT ASSEMBLY (for 2GR-FKS) >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY288947Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no excessive play in the radial direction of the inboard joint.
    4. Check the boots for damage.
    5. Check whether each drive shaft dimension (A) is within specification.
      NOTE:

      Keep the drive shaft assembly level during inspection.

      GTY680619Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Dimension (A) (for 2WD)

      for LH Side 604.75 mm (1.98 ft.)
      for RH Side 925.55 mm (3.04 ft.)

      Dimension (A) (for AWD)

      for LH Side 604.75 mm (1.98 ft.)
      for RH Side 926.55 mm (3.04 ft.)
scientia non olet · About LEMON Manuals