How To Proceed With Troubleshooting [12/2013 - 11/2016]: Procedure

Result

Result:  1

NEXT 

See step  2

Result

Result:  1

NEXT 

See step  3

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to DIAGNOSIS SYSTEM [12/2013 - 11/2016]

   Result

   Result	Proceed to
   CAN communication system DTCs are not output	A
   CAN communication system DTCs are output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - 11/2016] 

Result:  1

A 

See step  5

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - ] 

   Body Electrical > Main Body > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result:  2

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2013 - 11/2016]  

Result:  1

A 

See step  6

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [12/2013 - 11/2016] 

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

Result:  2

B 

GO TO PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2013 - 11/2016]  

Result:  1

A 

See step  7

1. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [12/2013 - 11/2016] 

2. Terminals of ECU

   Refer to TERMINALS OF ECU [12/2013 - 11/2016] 

3. Inspection

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

See step  9

Result

Result:  1

NEXT 

END