Reassembly [12/2013 - ]: Procedure

HINT: 

Fully tighten the rear disc brake bleeder plug after bleeding the system.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Lithium Soap Base Glycol Grease

   Apply lithium soap base glycol grease to the entire circumference of a new piston seal.

2. Install the piston seal to the rear disc brake cylinder.
   NOTE:

   Securely install the piston seal into the groove of the rear disc brake cylinder.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Rear Disc Brake Piston
   *2	Cylinder Boot
   	Lithium Soap Base Glycol Grease

   Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.

2. Install the cylinder boot to the rear disc brake piston.
3. Apply a light layer of lithium soap base glycol grease to the contact surfaces of the rear disc brake piston, and install it to the rear disc brake cylinder.
   NOTE:

   Do not forcibly install the rear disc brake piston into the rear disc brake cylinder.

1. Install the cylinder boot to the rear disc brake cylinder as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Securely install the cylinder boot into the groove of the rear disc brake cylinder and groove of the rear disc brake piston.
   • Do not damage the cylinder boot.