DTC B1810/53: Short in Driver Side Squib 2nd Step Circuit; DTC B1811/53: Open in Driver Side Squib 2nd Step Circuit; DTC B1812/53: Short to GND in Driver Side Squib 2nd Step Circuit; DTC B1813/53: Short to B+ in Driver Side Squib 2nd Step Circuit [08/2013 - 12/2013]: Description
WARNING: This page is about a different variant/trim than selected.
The driver side squib 2nd step circuit consists of the airbag sensor assembly, spiral cable with sensor sub-assembly and horn button assembly.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met.
These DTCs are stored when a malfunction is detected in the driver side squib 2nd step circuit.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1810/53 |
- The airbag sensor assembly receives a line short circuit signal in the driver side squib 2nd step circuit during primary check.
- Spiral cable with sensor sub-assembly malfunction
- Driver side squib 2nd step malfunction
- Airbag sensor assembly malfunction
|
- Instrument panel wire
- Spiral cable with sensor sub-assembly
- Horn button assembly (Driver side squib 2nd step)
- Airbag sensor assembly
|
| B1811/53 |
- The airbag sensor assembly receives an open circuit signal in the driver side squib 2nd step circuit.
- Spiral cable with sensor sub-assembly malfunction
- Driver side squib 2nd step malfunction
- Airbag sensor assembly malfunction
|
| B1812/53 |
- The airbag sensor assembly receives a short circuit to ground signal in the driver side squib 2nd step circuit.
- Spiral cable with sensor sub-assembly malfunction
- Driver side squib 2nd step malfunction
- Airbag sensor assembly malfunction
|
| B1813/53 |
- The airbag sensor assembly receives a short circuit to B+ signal in the driver side squib 2nd step circuit.
- Spiral cable with sensor sub-assembly malfunction
- Driver side squib 2nd step malfunction
- Airbag sensor assembly malfunction
|