DTC C1300: Skid Control ECU Malfunction [08/2013 - ]: Procedure

1. Replace the skid control ECU (brake actuator assembly). Refer to REMOVAL [08/2013 - 12/2013] .

   HINT: 

   This DTC is output when the skid control ECU detects a malfunction in the internal circuit.

2. Perform system variant learning. Refer to CALIBRATION [08/2013 - ] .
3. Perform the sensor check using the Test Mode procedure. Refer to TEST MODE PROCEDURE [08/2013 - ] .

NEXT → END