Green Indicator Remains Off [08/2013 - 12/2013]: Procedure
- CONFIRM GREEN INDICATOR COMES ON
- After the engine switch is turned on (IG) and the manual (SOS) switch red indicator has come on for 2 seconds, confirm that the manual (SOS) switch green indicator comes on for 2 seconds.
OK
Green indicator comes on.
NG → See step 6
OK: Go to next step
- After the engine switch is turned on (IG) and the manual (SOS) switch red indicator has come on for 2 seconds, confirm that the manual (SOS) switch green indicator comes on for 2 seconds.
- CONFIRM SUBSCRIPTION MODE
- Confirm the indicator status 5 seconds after the engine switch is turned on (IG).
Result
Result Proceed to Green indicator remains on A Green indicator remains off B Red and Green indicators both flash
(1 second intervals, for 20 seconds)C HINT:
If red and green indicators are flashing, the system is in shipping mode, so the system should be changed to either active mode or deactive mode.
B → See step 3
C → CHANGE SUBSCRIPTION MODE
A → See step 9
- Confirm the indicator status 5 seconds after the engine switch is turned on (IG).
- INPUT VIN WITH TECHSTREAM
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and wait for 10 seconds.
- Turn the Techstream on.
- Select "Vehicle Inquiry" and input the VIN.
NEXT: Go to next step
- CONFIRM SUBSCRIPTION MODE
- Confirm the indicator status at 5 seconds after the engine switch is turned on (IG).
Result
Result Proceed to Green indicator remains on A Green indicator remains off B
B → See step 5
A → END
- Confirm the indicator status at 5 seconds after the engine switch is turned on (IG).
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ]
.NOTE:
- The engine switch must be off.
- Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT → See step 10
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ]
.
- CHECK DTC
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and wait for 10 seconds.
- Turn the Techstream on.
- Perform "Health Check" and check for current DTCs. Refer to HEALTH CHECK [08/2013 - ]
.
Result
Result Proceed to DTC is not output A DTC is output B
B → See step 8
A: Go to next step
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ]
.NOTE:
- The engine switch must be off.
- Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT → See step 11
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ]
.
- GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2013 - ]
- CHECK FOR INTERMITTENT PROBLEMS. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - 12/2013]
- PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION [08/2013 - ]
- PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION [08/2013 - ]