Green And Red Indicators Do Not Come On When IG-On [08/2013 - 12/2013]: Procedure

HEALTH CHECK

Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG) and wait for 10 seconds.
Turn the Techstream on.

Perform "Health Check" using the Techstream and check that Telematics (Safety Connect) is listed on "Health Check Result". Refer to HEALTH CHECK [08/2013 - ] .

Result

Result	Proceed to
"Telematics" is displayed on the Techstream	A
"Telematics" is not displayed on the Techstream	B

B → See step 3

A: Go to next step

CHECK DTC

Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG) and wait for 10 seconds.
Turn the Techstream on.

Check current DTCs and history DTCs. Refer to DTC CHECK / CLEAR [08/2013 - ] .

Result

Result	Proceed to
DTC is not output	A
DTC is output	B

B → See step 5

A → See step 4

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2013 - 12/2013]
CHECK FOR INTERMITTENT PROBLEMS. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - 12/2013]
GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2013 - ]