DTC B1573: Short in Telephone Antenna Circuit; DTC B15CB: Telematics Transceiver Antenna Disconnected [08/2013 - 12/2013]: Procedure
- CHECK DTC
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and wait for 10 seconds.
- Turn the Techstream on.
- Perform "HEALTH CHECK" and check for current DTCs. Refer to HEALTH CHECK [08/2013 - ]
.
Result
Result Proceed to DTC B1573 or B15CB is output A DTC B1573 or B15CB is not output B
B → See step 6
A: Go to next step
- INSPECT TELEPHONE AND GPS ANTENNA ASSEMBLY
- Disconnect the telephone and GPS antenna assembly connector from the telephone and GPS antenna cord (No. 2 floor wire).
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 (TEL1) - 3a Always 4 to 11 kΩ TEXT IN ILLUSTRATION*a Telephone and GPS Antenna Assembly
NG → See step 4
OK: Go to next step
- Disconnect the telephone and GPS antenna assembly connector from the telephone and GPS antenna cord (No. 2 floor wire).
- INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 FLOOR WIRE)
- Disconnect the telephone and GPS antenna cord (No. 2 floor wire) connector from the DCM (Telematics Transceiver).
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition O34-3 (TEL1) - O36-1 (TEL2) Always Below 1 Ω O34-3a - O36-1a Always Below 1 Ω O34-3 (TEL1) - Body ground Always 10 kΩ or higher O34-3a - Body ground Always 10 kΩ or higher TEXT IN ILLUSTRATION*a Telephone and GPS antenna cord (No. 2 Floor Wire)
NG → REPLACE TELEPHONE AND GPS ANTENNA CORD (NO. 2 FLOOR WIRE)
OK: Go to next step
- Disconnect the telephone and GPS antenna cord (No. 2 floor wire) connector from the DCM (Telematics Transceiver).
- REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY
- Replace the telephone and GPS antenna assembly with a known good one and check if the same problem occurs again. Refer to REMOVAL [08/2013 - ]
.
OK
The system returns to normal.
NG → See step 5
OK → END
- Replace the telephone and GPS antenna assembly with a known good one and check if the same problem occurs again. Refer to REMOVAL [08/2013 - ]
.
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ]
.NOTE:
- The engine switch must be off.
- Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT → See step 7
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ]
.
- CHECK FOR INTERMITTENT PROBLEMS. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - 12/2013]
- PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION [08/2013 - ]