Disposal [10/2013 - ]

DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY
1. Fully extend the rear shock absorber piston rod.
  
  Fig 1: Identifying Where To Make Hole In Cylinder Component
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a drill, make a hole in the cylinder between A and B as shown in the illustration to discharge the gas inside.
  WARNING:
  Be careful when drilling as shards of metal may fly about, so always use proper safety equipment.
  
  HINT:
  
  The gas is colorless, odorless and non-poisonous.