Main Switch Power Source Circuit [10/2013 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (UPPER CONSOLE PANEL SUB-ASSEMBLY POWER SOURCE)
- Disconnect the D118 upper console panel sub-assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition D118-4 (GND1) - Body ground Always Below 1 Ω - Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition D118-2 (ACC) - D118-4 (GND1) Engine switch on (ACC) 11 to 14 V
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to next step
- INSPECT UPPER CONSOLE PANEL SUB-ASSEMBLY
- Disconnect the D118 and A upper console panel sub-assembly connectors.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition D118-2 (ACC) - A-11 (+B) Always Below 1 Ω D118-4 (GND1) - A-12 (E) Always Below 1 Ω TEXT IN ILLUSTRATION*a Component without harness connected
(Upper Console Panel Sub-assembly)
NG → See step 4
OK → See step 3
- Disconnect the D118 and A upper console panel sub-assembly connectors.
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [10/2013 - ]
- REPLACE UPPER CONSOLE PANEL SUB-ASSEMBLY. Refer to REMOVAL [10/2013 - ]