Green Indicator Remains Off [10/2013 - ]: Procedure

1. After engine switched on (IG) and the manual (SOS) switch red indicator has come on for 2 seconds, confirm that the manual (SOS) switch green indicator comes on for 2 seconds.

   OK

   Green indicator comes on.

NG → See step   7 

OK: Go to next step 

1. Confirm the indicator status at 5 seconds after engine switch on (IG).

   Result

   Result	Proceed to
   Green indicator remains on.	A
   Green indicator remains off.	B
   Red and Green indicators both flash (1 second intervals, for 20 seconds).	C

   HINT: 

   If the red and green indicators are flashing, the system is in shipping mode, so the system should be changed to either active mode or deactive mode.

B → See step   3 

C → CHANGE SUBSCRIPTION MODE 

A → See step   11 

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and wait for 10 seconds.
4. Turn the Techstream on.
5. Select "Vehicle Inquiry" and input VIN.

NEXT: Go to next step 

1. Confirm the indicator status at 5 seconds after engine switch on (IG).

   Result

   Result	Proceed to
   Green indicator remains on.	A
   Green indicator remains off.	B

B → See step   5 

A → END 

1. Replace the DCM (Telematics Transceiver). Refer to REMOVAL [10/2013 - ] .
   NOTE:

   • The engine switch must be off.
   • Do not replace the DCM (Telematics Transceiver) with one from another vehicle.

NEXT: Go to next step 

1. Perform "PRL UPDATE". Refer to PRL UPDATE [10/2013 - ] .

NEXT → See step   12 

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and wait for 10 seconds.
4. Turn the Techstream on.
5. Perform "Health Check" and check for current DTCs. Refer to HEALTH CHECK [10/2013 - ] .

   Result

   Result	Proceed to
   DTC is not output.	A
   DTC is output.	B

B → See step   10 

A: Go to next step 

1. Replace the DCM (Telematics Transceiver). Refer to REMOVAL [10/2013 - ] .
   NOTE:

   • The engine switch must be off.
   • Do not replace the DCM (Telematics Transceiver) with one from another vehicle.

NEXT: Go to next step 

1. Perform "PRL UPDATE". Refer to PRL UPDATE [10/2013 - ] .

NEXT → See step   13