LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2014 >> Avalon XLE >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Safety Connect System (Diagnostic Codes & Symptom Tests) (Except Hybrid) >> Safety Connect System >> Symptom Tests >> DCM Power Source Circuit [10/2013 - ] >> Procedure

DCM Power Source Circuit [10/2013 - ]: Procedure

  1. CHECK HARNESS AND CONNECTOR (DCM (TELEMATICS TRANSCEIVER) - BATTERY AND BODY GROUND) 
    1. Disconnect the E11 DCM (Telematics Transceiver) connector.
      GTY367243Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      E11-4 (E) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      E11-1 (+B) - E11-4 (E) Always 11 to 14 V
      E11-7 (IG2) - E11-4 (E) Engine switch on (IG) 11 to 14 V
      E11-8 (ACC) - E11-4 (E) Engine switch on (ACC) 11 to 14 V
      TEXT IN ILLUSTRATION

      *a Front view of wire harness connector
      (to DCM (Telematics Transceiver))

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   2 

  2. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2013 - ] 
scientia non olet · About LEMON Manuals