Guide Lines are Displayed with Vehicle Center Line [10/2013 - ]: Procedure

CHECK SCREEN MODE

Check the parking assist monitor screen.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Result

Result	Proceed to
Guide lines are displayed with vehicle center lines.	A
Guide lines are displayed without vehicle center lines.	B

TEXT IN ILLUSTRATION

*a	Vehicle Center Line

B → See step 4

A: Go to next step

CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
O6-1 (CURT) - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK → See step 3

REPLACE REAR TELEVISION CAMERA ASSEMBLY. Refer to REMOVAL [10/2013 - ]
USE SIMULATION METHOD TO CHECK (A WIRE MAY BE OPEN). Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE [10/2013 - ]