DTC C1626: Steering Angle Sensor Failure [10/2013 - ]: Procedure

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
1. Replace the spiral cable with sensor sub-assembly. Refer to REMOVAL [10/2013 - ] .
NEXT: Go to next step
CHECK DTC OUTPUT
1. Clear the DTCs. Refer to DTC CHECK / CLEAR [10/2013 - ] .
2. Check for DTCs. Refer to DTC CHECK / CLEAR [10/2013 - ] .
  OK
  
  DTC C1626 is not output.
NG → See step 3

OK → END
REPLACE NAVIGATION ECU SUB-ASSEMBLY. Refer to REMOVAL [10/2013 - ]