Removal [10/2013 - ]

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure described below is for the LH side.

1. PRECAUTION 

   Refer to PRECAUTION [10/2013 - ]

   NOTE:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Refer to PRECAUTION [10/2013 - ] .

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER  . Refer to REMOVAL [10/2013 - ] - Step 2
3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL 
4. REMOVE LIGHT CONTROL ECU 
   WARNING:

   The light control ECU may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the light control ECU is not hot before starting work.

   1. for LH Side:
      1. Disconnect the connector.
         Fig 1: Removing Light Control ECU (For LH Side)

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. for RH Side:
      1. Disconnect the connector.
         Fig 2: Removing Light Control ECU (For RH Side)

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the light control ECU See step  3.
5. REMOVE DISCHARGE HEADLIGHT BULB  See step  4