Removal [10/2013 - ]

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure described below is for the LH side.

1. PRECAUTION (for HID Headlight) 

   Refer to PRECAUTION [10/2013 - ]

   NOTE:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Refer to PRECAUTION [10/2013 - ] .

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER  . Refer to REMOVAL [10/2013 - ] - Step 2
3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL (for HID Headlight) 
4. REMOVE FRONT BUMPER ASSEMBLY 

   Refer to REMOVAL [10/2013 - ]

5. REMOVE HEADLIGHT ASSEMBLY 
   1. Remove the 3 screws and bolt.
      Fig 1: Headlight Assembly, Bolts & Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. for Halogen Headlight:
      1. Disengage the clamp.
         Fig 2: Identifying Clamp & Connectors (Halogen Headlight)

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Disconnect the 3 connectors to remove the headlight assembly.
   3. for HID Headlight:
      1. Disengage the clamp.
         Fig 3: Identifying Clamp & Connectors (HID Headlight)

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Disconnect the 5 connectors to remove the headlight assembly.