AWD Warning Light does not Come ON: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK CAN COMMUNICATION SYSTEM

Check if CAN communication system DTCs are output.

RESULT

Result	Proceed to
CAN communication system DTC is not output	A
CAN communication system DTC is output	B

HINT:

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.

B → See step 3

A: Go to next step

INSPECT AWD WARNING LIGHT
1. Disconnect the 4WD control ECU connector.
2. Turn the ignition switch to ON.
3. Check that the AWD warning light comes on.
  OK
  
  AWD warning light comes on.
NG → See step 5

OK → See step 4
REPAIR CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
REPLACE 4WD CONTROL ECU. Refer to REMOVAL
GO TO METER / GAUGE SYSTEM. Refer to PROBLEM SYMPTOMS TABLE