DTC Check / Clear

CHECK DTC
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
5. Check DTCs and then write them down.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
6. Confirm the details of the DTCs.
CLEAR DTC
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
5. Clear DTCs.
  HINT:
  
  Refer to the Techstream operator's manual for further details.