LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> RAV4 XLE, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System (Service Information) (Except Hybrid) >> Front Camera >> Removal [10/2015 - ] >> Procedure

Removal [10/2015 - ]: Procedure

  1. REMOVE NO. 2 FORWARD RECOGNITION COVER 
    1. Detach the 2 claws and 2 guides and remove the No. 2 forward recognition cover as shown in the illustration.
      GTY598488Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If these claws are detached separately, they may break. Detach the claws simultaneously.

  2. REMOVE NO. 1 FORWARD RECOGNITION COVER 
    1. Detach the 2 clips and 2 guides and remove the No. 1 forward recognition cover as shown in the illustration.
      GTY569990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Push the cover while keeping it parallel with the surface of the glass so as not to damage the clips and guides.

  3. REMOVE FORWARD RECOGNITION LATCH 
    1. Detach the 2 claws and 4 guides and remove the forward recognition latch as shown in the illustration.
      GTY562361Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FORWARD RECOGNITION CAMERA 
    1. Disconnect the connector.
      GTY569988Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 4 guides and remove the forward recognition camera as shown in the illustration.
      NOTE:
      • Do not pull the harness forcibly when disconnecting the connector.
      • If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.
      • If the forward recognition camera has been struck or dropped, replace it with a new one.
      • Do not apply excessive force.
  5. REMOVE FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY (w/ Camera Heater) 
    1. Disconnect the connector.
      GTY732945Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the connector clamp.
      GTY699088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    3. Remove the wire harness.
    4. Detach the guide and claw and remove the forward recognition with haeater hood sub-assembly.
scientia non olet · About LEMON Manuals