Inspection [12/2012 - 11/2013]: Procedure

1. Check the tires for wear and proper inflation pressure.

   Cold Tire Inflation Pressure

   Tire Size	Front kPa (kgf/cm2 , psi)	Rear kPa (kgf/cm2 , psi)
   225/65R17 102H	230 (2.3, 33)	230 (2.3, 33)
   235/55R18 99H	220 (2.2, 32)	220 (2.2, 32)

   Cold Tire Inflation Pressure (for Compact Spare Tire)

   Tire Size	kPa (kgf/cm2 , psi)
   T165/80R17 104M	420 (4.2, 60)

2. Using a dial indicator, check the runout of the tires.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Tire runout

   1.4 mm (0.0551 in.) or less

1. Rotate the tires as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A	w/ Full Size Spare Tire
   *B	w/o Full Size Spare Tire
   *a	Front of the Vehicle

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

1. for Aluminum Wheel Type:

   Check and adjust the off-the-car balance.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Maximum imbalance after adjustment

   8.0 g (0.0176 lb.)

   NOTE:

   • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
   • Do not touch the sticking surface of the tape.
   • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

     Width (A)

     25 mm (0.984 in.)

   • Push the balance weight firmly to adhere it to the position.
   • Do not reuse the balance weight.

   HINT: 

   • The inner side balance weights should be installed by clipping them to the rim.
   • If necessary, check and adjust the on-the-car balance.
2. for Steel Wheel Type:

   Check and adjust the off-the-car balance.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Maximum imbalance after adjustment

   8.0 g (0.0176 lb.)

   HINT: 

   If necessary, check and adjust the on-the-car balance.

Refer to ON-VEHICLE INSPECTION [12/2012 - ]

Refer to ON-VEHICLE INSPECTION [12/2012 - ]

Refer to ON-VEHICLE INSPECTION [12/2012 - ]

Refer to ON-VEHICLE INSPECTION [12/2012 - ]