LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> RAV4 LE, FWD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft / Propeller Shaft (Service Information) (Except Hybrid) >> FRONT DRIVE SHAFT ASSEMBLY (for AWD) >> Inspection [12/2012 - ] >> Procedure

Inspection [12/2012 - ]: Procedure

  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY313524Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no severe play in the radial direction of the inboard joint.
    4. Check the 2 joint boots for damage.
    5. Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.
      GTY370585Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for LH Side
      *B for RH Side

      Length (A)

      Item Length
      for TMMC Made LH Side 571.9 mm (1.88 ft.)
      RH Side 918.0 mm (3.01 ft.)
      except TMMC Made LH Side 577.6 mm (1.89 ft.)
      RH Side 922.4 mm (3.03 ft.)
      NOTE:

      Keep the drive shaft assembly level during inspection.

      If the boots are stretched or contracted, correct them.

scientia non olet · About LEMON Manuals