LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> RAV4 LE, AWD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension (Service Information) (Except Hybrid) >> Rear Upper Arm >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. REMOVE REAR WHEEL 
  2. DISCONNECT SKID CONTROL SENSOR WIRE LH 
    1. Remove the 2 nuts and disconnect the skid control sensor wire from the rear upper control arm.
      GTY368005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH 
    GTY368004Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using a jack and wooden block, raise the vehicle and hold the rear No. 2 suspension arm assembly LH together with the rear axle carrier at the standard vehicle height.
    2. Remove the 2 bolts, 2 nuts and upper control arm.
      GTY370527Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Since a stopper nut is used, remove the bolt.

scientia non olet · About LEMON Manuals