Installation [12/2012 - ]: Procedure

1. Temporarily install the rear No. 2 suspension arm to the suspension member with the bolt and nut.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the rear upper coil spring insulator to the rear coil spring.
   NOTE:

   Install the rear upper coil insulator so that the distance between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.

1. Install the rear lower coil spring insulator to the rear No. 2 suspension arm.

1. Install the rear coil spring to the rear No. 2 suspension arm.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

   NOTE:

   Install the rear coil spring so that the identification marks are positioned as shown in the illustration.

2. Using a jack and wooden block, raise the vehicle gradually to install the rear No. 2 suspension arm to the rear axle carrier. Then temporarily install the bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  7

1. Temporarily install the rear No. 1 suspension arm to the rear axle carrier with a new nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Insert the rear suspension toe adjust cam sub-assembly from the rear of the vehicle to install the rear No. 1 suspension arm assembly LH, and then temporarily install the No. 2 camber adjust cam with the nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  2

See step  3

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Tighten the 2 bolts and nut of the rear No. 2 suspension arm assembly.

   Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf) 

   NOTE:

   Since a stopper nut is used, tighten the bolt.

See step  4

1. Insert the 2 claws of the rear suspension arm cover LH into the rear No. 2 suspension arm assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the rear suspension arm cover LH with the 2 bolts.

   Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

   NOTE:

   Make sure that the 2 claws of the rear suspension arm cover are inserted.

1. Tighten the nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 100 N*m (1020 kgf*cm, 74 ft.*lbf) 

2. Tighten the nut of the rear No. 1 suspension arm.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 120 N*m (1224 kgf*cm, 89 ft.*lbf) 

   NOTE:

   Align the matchmarks on the rear suspension member and adjust cam.

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

Refer to ADJUSTMENT [12/2012 - 08/2017] Refer to ADJUSTMENT [08/2017 - ]