Removal [12/2012 - ]: Procedure

See step  3

See step  3

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Loosen the 2 bolts of the suspension arm.
   NOTE:

   • Do not remove the bolts and nuts, only loosen them.
   • Since a stopper nut is used, loosen the bolt.

1. Support the No. 2 suspension arm LH with a jack.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Place a wooden or rubber block between the jack and arm.

2. Remove the bolt located on the rear axle carrier of the rear No. 2 suspension arm.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Lower the jack gradually to remove the rear coil spring together with the rear upper coil spring insulator.

1. Remove the rear upper coil spring insulator from the rear coil spring.

1. Remove the rear lower coil spring insulator from the rear No. 2 suspension arm.