LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> RAV4 LE, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (2AR-FE) (Service Information) (1 Of 2) (Except Hybrid) >> Front Crankshaft Oil Seal >> Installation [12/2012 - ] >> Procedure

Installation [12/2012 - ]: Procedure

  1. INSTALL TIMING CHAIN COVER OIL SEAL 
    1. Apply MP grease to the lip of a new oil seal.
      NOTE:
      • Do not allow foreign matter to contact the lip of the oil seal.
      • Do not allow MP grease to contact the dust seal.
    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
      GTY190378Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09223-22010 
      NOTE:
      • Keep the lip of the oil seal free from foreign matter.
      • Do not tap in the oil seal at an angle.
  2. INSTALL CRANKSHAFT PULLEY 

    Refer to PROCEDURE - Step 44 [12/2012 - 08/2017] , or refer to PROCEDURE - Step 44 [08/2017 - ]

  3. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH 

    See step  16

  4. INSTALL FAN AND GENERATOR V BELT 

    See step  1

  5. CONNECT RADIATOR RESERVOIR ASSEMBLY 

    See step  3

  6. INSTALL REAR ENGINE UNDER COVER RH 

    See step  78

  7. INSTALL NO. 1 ENGINE UNDER COVER 

    See step  79

scientia non olet · About LEMON Manuals