LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> RAV4 LE, AWD >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2AR-FE) (Service Information) (Except Hybrid) >> Water Pump >> Installation [12/2012 - 08/2016] >> Procedure

Installation [12/2012 - 08/2016]: Procedure

  1. INSTALL ENGINE WATER PUMP ASSEMBLY 
    1. Install a new water pump gasket and the engine water pump assembly with the 7 bolts.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

    2. Install the wire harness bracket with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Attach the clamp of the wire harness to the wire harness bracket.
  2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY 
    1. Install the V-ribbed belt tensioner assembly with the bolt.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

  3. INSTALL GENERATOR ASSEMBLY 

    Refer to INSTALLATION [12/2012 - ]

  4. ADD ENGINE COOLANT 

    See step  3

  5. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  6. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 79

  7. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

scientia non olet · About LEMON Manuals