LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> RAV4 LE, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) (Service Information) (Except Hybrid) >> Brake Master Cylinder >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to REMOVAL [12/2012 - ]

  2. DRAIN BRAKE FLUID 
    NOTE:

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY 
    GTY374255Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Release the vacuum pressure in the brake booster as follows.
      1. Stop the engine.
      2. Depress the brake pedal several times.
    2. Disconnect the brake fluid level warning switch connector labeled A.
    3. Using a union nut wrench, disconnect the 2 brake lines labeled B from the brake master cylinder.
    4. Remove the 2 nuts.
    5. Pull out the brake master cylinder from the brake booster.
      GTY362201Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.
      • Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
    6. Remove the O-ring from the brake master cylinder.
scientia non olet · About LEMON Manuals