Rear Upper Arm: Removal: Removal

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL 
2. DISCONNECT SKID CONTROL SENSOR WIRE LH 
   1. Remove the 2 nuts and disconnect the skid control sensor wire from the rear upper control arm.
      Fig 1: Identifying Skid Control Sensor Wire

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH 
   Fig 2: Removing Rear Upper Control Arm Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Using a jack and wooden block, raise the vehicle and hold the rear No. 2 suspension arm assembly LH together with the rear axle carrier at the standard vehicle height.
   2. Remove the 2 bolts, 2 nuts and upper control arm.
      Fig 3: Locating Upper Control Arm Bolts And Nuts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Since a stopper nut is used, remove the bolt.