LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> RAV4 EV >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (HYBRID CONTROL SYSTEM (DIAGNOSTIC CODES (BMS_f001 - CHG_f075)) (ELECTRIC)) >> Hybrid Control System >> DTC CHG_f074: Hardware Fault has Occurred [09/2013 - ] >> Procedure

DTC CHG_f074: Hardware Fault has Occurred [09/2013 - ]: Procedure

WARNING: This page is about a different car, the 2014 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR ANY OTHER ALERT CODES OUTPUT 
    1. Connect the RAV4 EV diagnostic tool to the No. 2 DLC3.
    2. Turn the power switch on (READY).
    3. Turn the RAV4 EV diagnostic tool on.
    4. Enter the following menus: Alert List.
    5. Read the alert codes.
      RESULT

      Result Proceed to
      Only CHG_f074 is output A
      CHG_f074 and other alert codes are output B

      HINT: 

      If any alert codes other than CHG_f074 are output, troubleshoot those alert codes first.

    B → See step   2 

    A → See step   3 

  2. GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2013 - ] 
  3. REPLACE ELECTRIC VEHICLE CHARGER ASSEMBLY. Refer to  REMOVAL [09/2013 - ] 
scientia non olet · About LEMON Manuals