DTC BMS_f146: Overdischarged Cell is Preventing Recharge [09/2013 - ]: Procedure
WARNING: This page is about a different car, the 2014 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- RECHARGE ELECTRIC VEHICLE BATTERY ASSEMBLY (PROPER CHARGING CABLE AND PLUG)
- Recharge the electric vehicle battery.
HINT:
Properly recharge the vehicle using proper equipment, etc.
- Connect the RAV4 EV diagnostic tool to the No. 2 DLC3.
- Turn the power switch on (READY).
- Turn the RAV4 EV diagnostic tool on.
- Enter the following menus: Alert List.
- Read the alert codes.RESULT
Result Proceed to Alert code is not output A BMS_f146 is output B
B → See step 2
A → ALERT CODE CAUSED BY TOO LOW SOC CONDITION (NO REPAIR IS NECESSARY)
- Recharge the electric vehicle battery.
- REPLACE ELECTRIC VEHICLE BATTERY ASSEMBLY. Refer to REMOVAL [09/2013 - ]