SOC Gauge Malfunction: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   CAN communication system DTC is not output	A
   CAN communication system DTC is output	B

B → See step   6 

A: Go to next step 

1. Using the Techstream, perform the Active Test. Refer to DATA LIST / ACTIVE TEST .
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   SOC Gauge	SOC gauge	SOC Warn, MIN, 1/4, 1/2, 3/4 or MAX	-

   OK

   SOC gauge indication is normal.

NG → See step   4 

OK: Go to next step 

1. Replace the combination meter assembly with a new or normally functioning one. Refer to REMOVAL .

   OK

   The operation of the SOC gauge returns to normal.

NG → See step   5 

OK → END (COMBINATION METER ASSEMBLY WAS DEFECTIVE)