EV System Indicator Malfunction: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   CAN communication system DTC is not output	A
   CAN communication system DTC is output	B

B → See step   7 

A: Go to next step 

1. Using the Techstream, perform the Active Test. Refer to DATA LIST / ACTIVE TEST .
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   EV System Indicator	EV system Indicator	MIN, -50, 0, 100, 200, 300, 400 or MAX (%)	The MAX value is indicated when 200, 300, 400 and MAX is selected.

   OK

   EV system indicator indication is normal.

NG → See step   5 

OK: Go to next step 

1. Using the Techstream, read the Data List. Refer to DATA LIST / ACTIVE TEST .
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   EV System Indicator	EV system indicator value / Min.: -512 %, Max.: 511 %	-512 to 511 %	-

   OK

   EV system indicator value displayed on the Techstream is almost the same as EV system indicator indication.

NG → See step   6 

OK: Go to next step 

1. Replace the combination meter assembly with a new or normally functioning one. Refer to REMOVAL .

   OK

   The operation of the EV system indicator returns to normal.

NG → See step   8 

OK → END (COMBINATION METER ASSEMBLY WAS DEFECTIVE)