LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> Prius V >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Battery Management Systems >> Hybrid Battery System (Diagnostic Codes (P0A7F-123 - U029A-123)) >> Hybrid Battery System >> DTC P0A80-123: Replace Hybrid Battery Pack >> Confirmation Driving Pattern

Confirmation Driving Pattern

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off.
  5. Turn the power switch on (READY) and turn the Techstream on.
  6. Perform a universal trip.
  7. With the select lever in N, leave the vehicle until SOC drops to 30%.

    HINT: 

    Although DTC P3000 (INF 388) may be stored if the SOC drops to 20% or lower, this is not a malfunction.

  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
  9. Check that permanent DTCs are cleared.

    HINT: 

    • If the permanent DTC is not cleared, repeat steps 6 and 7.
    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals