DTC B1695/16: Door Side Airbag Sensor LH Malfunction: Procedure

1. Turn the ignition switch off.
   Fig 1: Identifying Door Side Airbag Sensor Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the cable from the negative (-) auxiliary battery terminal.
   WARNING:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Interchange the door side airbag sensor LH with RH and connect the connectors.
4. Connect the cable to the negative (-) auxiliary battery terminal.
5. Clear the DTCs stored in memory. Refer to DTC CHECK / CLEAR .
6. Turn the ignition switch off.
7. Turn the ignition switch to ON (IG), and wait for at least 60 seconds.
8. Check for DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC B1695/16 is output.	A
   DTC B1690/15 is output.	B
   DTCs B1690/15 and B1695/16 are not output.	C

   HINT: 

   Codes other than DTCs B1690/15 and B1695/16 may be output at this time, but they are not related to this check.

9. Turn the ignition switch off.
10. Disconnect the cable from the negative (-) auxiliary battery terminal.
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

11. Return the door side airbag sensor LH and RH to their original positions and connect the connectors.
    TEXT IN ILLUSTRATION
    
    

    *1	Door Side Airbag Sensor RH
    *2	Side No. 2 Airbag Sensor Assembly LH

B → See step   3 

C → See step   4 

A → See step   2